Installing TomTom 550.

Stevezx7Stevezx7 Posts: 2 [Apprentice Traveler]
edited June 15 in RIDER
Hi everyone am after some advice I used to use my trusty old rider v2 but it ended its life sometime ago, I have since bought a rider 550. Instead of routing new cables can I tap into the previous wiring for my rider v2? Maybe just installing direct to battery would be better but I know my old gps unit is wired into the front indicator wiring, done by the shop when I bought my XT660Z Teneré so it's only powered when the bike is turned on. I know it's pretty basic stuff to wire direct & from what I have read online it does not drain much power when the bike is turned off (with gps unit removed!). So could I use the previous install cables to tap into & run my new unit or would you advice a complete fresh hard wire direct? Many thanks in advance all....

Answers

Sign In or Register to comment.

Who's Online76

bastle
bastle
Briese
Briese
DrBakteriusTT
DrBakteriusTT
Jim07
Jim07
Mactoni
Mactoni
Metoalent
Metoalent
Niall
Niall
Niedermaier
Niedermaier
Palferman
Palferman
RicoK
RicoK
usatravel
usatravel
+65 Guests