Go Live 1005 rebooting

Erikq
Registered Users Posts: 1 
New Traveler

New Traveler
My Go Live product run a wheeler in the right hand side and after few second they do a restart.
Updated to current version of software.
I have also tried a cold start and a total cold with 3 times interruption.
Still the same problem with the running wheeler in the right side
Updated to current version of software.
I have also tried a cold start and a total cold with 3 times interruption.
Still the same problem with the running wheeler in the right side

0
Comments
-
Best you chat with support:
:flag_dk: Danmark
Now Chat only
Chattimerne er angivet nedenfor.
Mandag - Onsdag: 10:00 Formiddag - 01:00 Eftermiddag, 02:00 Eftermiddag - 05:00 Eftermiddag CEST
Torsdag: 11:45 Formiddag - 01:00 Eftermiddag, 02:00 Eftermiddag - 05:00 Eftermiddag CEST
Fredag: 10:00 Formiddag - 01:00 Eftermiddag, 02:00 Eftermiddag - 05:00 Eftermiddag CEST
Lørdag - Søndag: Lukket0 -
Did your problems start after a tomtom map upgrade ?
And does your device start but locks up then restarts itself and is stuck in this loop ?
It is fixable but you need to use you computer and the TOMTOM software MY DRIVE CONNECT to change the map from the FULL map to a SMALLER “ZONE” map
Towards the end of page 1 of thread below and continued onto page 2:-
https://discussions.tomtom.com/en/discussion/1032274/go-live-1005-keeps-turning-off-freezing-rebooting/p1
The key bit is here and posted by johnst:-
OK
I will tell you how I have succeeded:
- hold the start button until drum sound is heard.
- wait 10 to 20 seconds
- press the start button again to switch off
- briefly press the start button again
repeat until the device starts normally
When the device has started:
- connect the device directly to the computer
- download a smaller part of the map (not as usual the entire map)
Connection to the PC is only possible if the device has been started normally0 -
0