not showing correct speed on M4 roadworks.
Lydden
Posts: 2 [Apprentice Traveler]
I have a TomTom when I need directions but use the android app for checking my speed, I had the speed app but this recently updated to the Amigo App , just one bit seems wrong while on the M4 near Reading there is a 21 mile average speed section of road works, on the old app this would show as 50 mph and go orange if you exceeded 50mph , the Amigo app is showing the speed limit as 70 mph so stays gray the whole time is this a programming fault ?
1
Best Answer
-
VikramK
Posts: 12,727 
Moderator
Hi Lydden
Welcome to the community!
It probably sounds like a map error with the speed limits in that section of the route not updated in our database.
Could you report this using our MapShare website. Correction for speed limits takes longer than the standard map corrections to reflect on the actual map as these are subject to frequent changes. Our teams try to get this accurate as much as we can.
Thanks
Vikram6
Answers
Welcome to the community!
It probably sounds like a map error with the speed limits in that section of the route not updated in our database.
Could you report this using our MapShare website. Correction for speed limits takes longer than the standard map corrections to reflect on the actual map as these are subject to frequent changes. Our teams try to get this accurate as much as we can.
Thanks
Vikram
I have tried to go on to the Map share website via a couple of methods but all I am getting is a blank grey screen, the section of M4 affected by the incorrect speed limit goes from junction 4 to junction 12 , can you pass this information on ?
Thanks for sending across the requested information.
I have added the correction using MapShare.
Regards
Vikram